FixVault
Home › Cadillac › 2005 › Escalade EXT › Repair and Diagnosis › Accessories & Equipment › Infotainment › Entertainment System › Repair Instructions › Radio Antenna Module Cable Replacement (From Radio to Module) › Installation Procedure

Installation Procedure

    Fig 1: Radio Cable Clips At A-Pillar
    GM798111Courtesy of GENERAL MOTORS CORP.
  1. Install the cable clips (1) to the A-pillar.
  2. Connect the electrical wire connector (4).
  3. Connect the cable (3) to the radio.
    4. Fig 2: Radio Antenna Module, Cable & Cable Clips At Roof
    GM798113Courtesy of GENERAL MOTORS CORP.
  4. Install the cable clips (1) to the roof.
  5. Connect the cable (2) to the radio antenna module.
  6. Connect the wire connector to the radio antenna module.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the bolt retaining the radio antenna module to the roof.

    Tighten:  Tighten the retaining bolt to 9 N.m (80 lb in).

  8. Install the headliner. Refer to Headliner Replacement in Interior Trim.
  9. Install the I/P trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Upper in Instrument Panel, Gages and Console.
About FixVault