Installation Procedure

WARNING: This page is about a different car, the 2005 GMC Yukon XL, 2005 Chevrolet Suburban, and 2005 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Knock Sensor (KS) 1

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the knock sensor.
Tighten: Tighten the sensor to 20 N.m (15 lb ft)

Fig 2: View Of Knock Sensor (KS) 1 Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the knock sensor electrical connector (4).
Fill the cooling system/engine block. Refer to Draining and Filling Cooling System in Engine Cooling.