Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the brackets to the vehicle and hand tighten the nuts.

Fig 1: Installing Tool Storage Compartment Bracket (PRO)

Courtesy of GENERAL MOTORS CORP.

Install the tool storage compartment. Refer to Tool Storage Compartment Replacement (PRO) .

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten the nuts that retain the tool storage compartment brackets (1), (2) to the seat riser studs.
Tighten: Tighten the nuts to 50 N.m (36 lb ft).
Install the rear seat hinge filler panel cover and plastic push pins.