Method 1 - Key Fob Quick Learn

This procedure is used when adding key fobs. Fobs will be numbered in sequence based on when they are programmed; if 2 fobs are currently programmed to the RCDLR, a fob programmed using this method will be numbered as Fob 3. This procedure requires that you have 2 known good key fobs, a replacement key fob, and the vehicles mechanical key.

IMPORTANT: This procedure is not available when the maximum number of fobs (4) have been programmed. If 4 key fobs are programmed to this RCDLR and this method is attempted, the driver information center (DIC) will display MAX FOBS LEARNED and the programming procedure will exit. Method 2 must be used in this instance.

The vehicle must be OFF.
Open the rear compartment.
Place 2 known key fobs within the interior of the vehicle.
At the rear of the vehicle insert the vehicle key in the rear compartment lock cylinder located in the lower left and cycle the key 5 times within 5 seconds.
The DIC will display a message: READY FOR FOB X (X = fob 2, 3, or 4).
Place the new unknown key fob in the glove box fob pocket with the buttons facing right.
A beep will occur and the DIC will display: READY FOR FOB X or MAX FOBS LEARNED.
If programming additional key fobs, repeat steps 5-6, or press the OFF/ACC portion of the ignition switch to exit programming mode.
Operate the active portion of each key fob to finalize the programming and verify correct system operation.