Conditions for Clearing the DTC
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DTC P1114
| Step | Action | Values | Yes | No |
|---|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Engine Controls Connector End Views or Engine Control Module (ECM) Connector End Views |
||||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Are DTCs P0641 or P0651 set? | - | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | Go to Step 3 |
| 3 |
IMPORTANT:
The cooling fans will be commanded ON when certain engine coolant temperature (ECT) DTCs are set. Observe the ECT Sensor parameter with a scan tool.Is the ECT Sensor parameter more than the specified value? |
138°C (280°F) | Go to Step 5 | Go to Step 4 |
| 4 |
|
- | Go to Step 5 | Go to Inducing Intermittent Fault Conditions in Wiring Systems and Intermittent Conditions |
| 5 |
|
-39°C (-38°F) | Go to Step 7 | Go to Step 6 |
| 6 | Test the ECT signal circuit for an intermittent short to ground or an intermittent short to the ECT low reference circuit. Refer to Circuit Testing
, Inducing Intermittent Fault Conditions
, and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 8 |
| 7 | Test for an intermittent and for a poor connection at the ECT sensor. Refer to Testing for Intermittent Conditions and Poor Connections
, Inducing Intermittent Fault Conditions
, Connector Repairs
and Repairing Connector Terminals
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 9 |
| 8 | Test for an intermittent and for a poor connection at the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections
, Inducing Intermittent Fault Conditions
, Connector Repairs
and Repairing Connector Terminals
in Wiring Systems. Did you find and correct the condition? |
- | Go to Step 11 | Go to Step 10 |
| 9 | Replace the ECT sensor. Refer to Engine Coolant Temperature (ECT) Sensor Replacement
. Did you complete the replacement? |
- | Go to Step 11 | - |
| 10 | Replace the ECM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
- | Go to Step 11 | - |
| 11 |
|
- | Go to Step 2 | Go to Step 12 |
| 12 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | System OK |