Installation Procedure
- Install the electronic lock module onto the steering column.
- Feed the electronic column lock lead into the wire harness assembly.
- Install new wire harness straps.
- Install the turn signal cancel cam. Refer to Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement .
- Install the windshield wiper wash and switch assembly. Refer to Wipers/Washer Switch Replacement in Wipers/Washer Systems.
- Install the multifunction switch assembly. Refer to Multifunction, Turn Signal Switch Replacement .
- Install the steering column into the vehicle. Refer to Steering Column Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
NOTE:
Avoid damaging the steering column electronic lock harness by gently removing the plugs installed in the I/P beam. Do NOT twist, pull, bend, cut, or incorrectly route the harness. Damage to the harness will require replacement of the entire electronic lock.