FixVault
Home › Cadillac › 2006 › DTS 4.6 Y › Repair and Diagnosis › Engine Performance › System › Engine Control System - 4.6L - Introduction (2 Of 2) › Repair Instructions › Camshaft Position (CMP) Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: CKP Sensor Wiring Harness
    GM1672927Courtesy of GENERAL MOTORS CORP.
  4. Connect the CKP sensor wiring harness electrical connector (1) to the CMP sensor.
About FixVault