FixVault
Home › Cadillac › 2006 › DTS 4.6 Y › Repair and Diagnosis › Engine Performance › System › Engine Control System - 4.6L - Introduction (2 Of 2) › Repair Instructions › Fuel Tank Pressure Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Fuel Level Sensor Wiring Harness Electrical Connector
    GM1671971Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel tank pressure sensor.
  2. Connect the fuel level sensor wiring harness electrical connector (1) to the fuel tank pressure sensor.
    3. Fig 2: Fuel Sender Access Hole Cover
    GM1671970Courtesy of GENERAL MOTORS CORP.
  3. place the fuel sender access hole cover into position.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the fuel sender access hole cover bolts.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Install the rear compartment liner. Refer to Rear Compartment Liner Replacement .
About FixVault