FixVault

Installation Procedure

  1. Install the antenna module (3) to the roof.
  2. Fig 1: Removing Antenna Module & Electrical Connector
    GM741404Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the module bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  4. Connect the antenna cable to the module (3), if disconnected.
  5. Connect the connector (2) to the rear quarter glass panel (1).
  6. Fig 2: Removing Cable Clips & Cable From Roof Cross Member
    GM798115Courtesy of GENERAL MOTORS CORP.
  7. Install the cable (2, 3) to the roof cross member by pushing in the retainer clips (1).
  8. Fig 3: Removing Radio Control Module & Electrical Connector
    GM741403Courtesy of GENERAL MOTORS CORP.
  9. Install the module bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  10. Connect the antenna cable to the module (1).
  11. Connect the connector (2) to the rear quarter glass panel (3).
  12. Install the headliner. Refer to Headliner Replacement in Interior Trim.