Removal Procedure

Fig 1: View Of Front Door Window Regulator

Courtesy of GENERAL MOTORS CORP.

Raise the window to the full up position.
Remove the door trim panel. Refer to Front Side Door Trim Panel Replacement .
Remove the water deflector. Refer to Water Deflector, Check Link Replacement - Front Door .
Raise and support the window in the full up position.
Through the access holes in the inner door panel, loosen the window clamp nuts 4 revolutions.
Connect the door trim panel wiring harness.
Lower the window regulator 3/4 of the way down.
Disconnect the electrical connector from the window regulator motor.
Remove the window regulator bolts (1, 2, 3, 4, 5).
Remove the window regulator from the door.