Component Testing

Static Test

1. Ignition OFF, disconnect the harness connector at the SCB solenoid.
2. Test for 30-55 ohms of resistance between the control terminal and the voltage supply terminal of the SCB solenoid.
   • If the resistance is not within the specified range, replace the SCB solenoid.

Dynamic Test

1. Install a 3A fused jumper wire between the ignition supply circuit terminal and 12 volts. Install a jumper wire between the control terminal and ground.
2. Toggle the jumper wire between the control terminal and ground.
3. Feel and listen for the operation of the SCB solenoid.
   • If the function does not perform as specified, replace the SCB solenoid.