FixVault
Home › Cadillac › 2006 › STS V › Repair and Diagnosis › External Pages › Different car › Section 12 (HVAC System - Automatic) › Repair Instructions › HVAC Control Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating HVAC Control Module Screws
    GM756525Courtesy of GENERAL MOTORS CORP.
  1. Install the HVAC control module into the trim plate.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the HVAC control module screws (1).

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 2: View Of HVAC Control Module Electrical Connector
    GM756502Courtesy of GENERAL MOTORS CORP.
  3. Connect the HVAC control module electrical connector.
  4. Connect the ash tray electrical connector.
    5. Fig 3: View Of Ashtray Assembly
    GM700907Courtesy of GENERAL MOTORS CORP.
  5. Install the HVAC control module trim plate by pressing trim until tabs engage.
  6. Install the screw behind the ashtray.

    Tighten:  Tighten the screw to 2 N.m (18 lb in).

  7. Refer to Control Module References for programming and setup information.
About FixVault