Scan Tool Data Definitions
- Accy. Indicator Command
-
The scan tool displays the status of the accessory indicator.
- Accy. Relay Command
-
The scan tool displays the status of the accessory output.
- Auxiliary Power
-
The scan tool displays the status of the auxiliary power relay.
- Battery Voltage Signal
-
The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the module ignition feed input.
- Brake Apply Sensor Reference Signal
-
The scan tool displays the voltage read by the brake apply sensor.
- Current Power Mode
-
The scan tool displays the current power mode.
- Idle Boost Level
-
The scan tool displays the level of the idle boost.
- Ignition Mode Switch
-
The scan tool displays the voltage and the state read by the module from the ignition mode switch.
- Ign. Mode Sw. Dimming Command
-
The scan tool displays the status of the ignition mode switch dimming.
- Inadvertent Power Cmd.
-
The scan tool indicates the status of the inadvertent power command.
- Inadvertent Power Signal
-
The scan tool displays the status of the inadvertent power signal.
- Key in Cylinder Switch
-
The scan tool displays if the key is in the trunk cylinder switch.
- Off Indicator Command
-
The scan tool displays the status of the Off indicator.
- Run/Crank Relay Command
-
The scan tool displays if the run/crank relay is controlled or not by the module.
- Run/Crank Relay Status
-
The scan tool displays the status of run/crank relay.
- Start Indicator Command
-
The scan tool displays the status of the start indicator.