FixVault
Home › Cadillac › 2006 › XLR Base › Repair and Diagnosis › Electrical › Instrument Panel System Displays, Gauges And Console › Repair Instructions › Console Replacement › Installation Procedure

Installation Procedure

  1. Install the console to the vehicle.
  2. Install the console lamp to the bin. Route the lamp through the hole in the bin and push to engage the retainer.
  3. Install the electrical accessory plug housing to the console. Verify that the cover plug is in place on the accessory plug housing.
  4. Install the electrical accessory plug retainer onto the accessory plug housing. Screw the retainer onto the housing until secure.
  5. Connect the electrical connector to the electrical accessory plug.
    6. Fig 1: Installing Front Of Console Under Rear Of I/P Carrier
    GM95703Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install the front of the console under the rear of the I/P carrier.
  6. Install the console into position. Insert the front of the console under the rear of the I/P carrier.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the console retaining nuts and the retaining bolt to the I/P carrier.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  8. Install the console trim plate. Refer to Console Trim Plate Replacement .
    9. Fig 2: View Of Ashtray Components
    GM1276318Courtesy of GENERAL MOTORS CORP.
  9. Install the console cupholder and the ashtray.
    10. Fig 3: View Of Console Door To Hinge Screws
    GM1224732Courtesy of GENERAL MOTORS CORP.
  10. Install the hinge cover to the console bin. Push down on the cover to engage the retaining clips.
  11. Close the console door. Verify that the door fits and latches correctly.
  12. Install the shifter knob. Refer to Transmission Control Lever Knob Replacement in Automatic Transmission - 5L50-E.
  13. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
About FixVault