FixVault
Home › Cadillac › 2006 › XLR Base › Repair and Diagnosis › External Pages › Different car › Section 56 (Front Suspension System) › Repair Instructions › Shock Module Yoke Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Yoke
    GM874641Courtesy of GENERAL MOTORS CORP.
  1. Install the yoke to the vehicle.
    2. IMPORTANT: Do not tighten the nut at this time.
    Fig 2: View Of Yoke-To-Lower Control Arm Retaining Nut
    GM874633Courtesy of GENERAL MOTORS CORP.
  2. Install the yoke to lower control arm retaining nut.
    3. Fig 3: View Of Shock-To-Yoke Retaining Bolt
    GM1209258Courtesy of GENERAL MOTORS CORP.
  3. Install the yoke to the shock.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the yoke to shock retaining bolt and nut.

    Tighten: 

    • Tighten the shock to yoke nut to 110 N.m (81 lb ft).
    • Tighten the yoke to lower control arm nut to 180 N.m (133 lb ft).

  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  6. Lower the vehicle.
About FixVault