FixVault
Home › Cadillac › 2007 › CTS V › Repair and Diagnosis › Accessories & Equipment › Memory Modules › Secondary And Configurable Customer Controls › Description and Operation › Driver Personalization › Personalization Name

Personalization Name

This feature allows you to type in a name that will appear on the DIC display whenever the corresponding remote keyless entry transmitter is used or one of the buttons on the driver door armrest (1 or 2) is pressed.

If a customized name is not programmed, the system will Driver 1 or Driver 2 to correspond with the numbers on the back of the remote keyless.

Base Audio System 

To program a name use the following procedure:

  1. Select the PERSONALIZATION NAME menu item by pressing the scroll/select knob once. You will see a blinking cursor.
  2. Turn the scroll/select knob until you reach the first letter you want to highlight. There is a complete alphabet with both upper and lower case letters and numbers zero through nine. Also included are spaces and other non-letter characters such as the ampersand (&).
  3. Press the scroll/select knob once to select the letter. The letter will then appear on the display. If you make a mistake, press the back key this will exit the menu. You can then go back into the menu and edit the name.
  4. Repeat steps 2 and 3 until the name you want is complete. You can program up to 26 characters.
  5. Press the BACK button located to the lower right of the display to exit and set your choice.

Navigation System 

To program a name use the following procedure:

  1. Press the button with the dot on it located to the right of the display that is next to the EDIT prompt. This will open the EDIT menu. You will see an alphabet at the bottom of the display and a blank line with a blinking cursor.
  2. Scroll to the first letter you want to highlight.
  3. Press the scroll/select knob once to select the letter. The letter will then appear on the line above the alphabet.
  4. Repeat steps 2 and 3 until the name you want is complete.
  5. Press the button with the dot on it located to the right of the display that is next to the Back prompt to exit and set your choice.
  6. The name you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available.
About FixVault