FixVault
Home › Cadillac › 2007 › CTS V › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 6.0L - Introduction (2 Of 2) › Repair Instructions › Camshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS CORP.
  1. Reconnect the camshaft sensor (5) and the jumper harness (4).
  2. Install the O-ring (6) on the camshaft sensor assembly (4 and 5).
  3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
    4. IMPORTANT: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
  4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
    5. NOTE: Refer to Fastener Notice .
  5. Install the camshaft position sensor mounting bolts.

    Tighten:  Tighten the camshaft position mounting bolts 25 N.m (18 lb ft).

  6. Install the crankshaft balancer assembly. Refer to Crankshaft Balancer Replacement .
  7. Install the accessory drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement .
  8. Install the air conditioning drive belt. Refer to Drive Belt Replacement - Air Conditioning .
  9. Install the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
About FixVault