FixVault
Home › Cadillac › 2007 › CTS V › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 6.0L - Introduction (2 Of 2) › Repair Instructions › Crankshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of CKP Sensor & Bolt
    GM55322Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CKP sensor retaining bolt.

    Tighten:  Tighten the CKP sensor to 25 N.m (18 lb ft).

    3. Fig 2: Identifying Crankshaft Position (CKP) Sensor/Connector
    GM56592Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP sensor electrical connector.
  4. Install the starter. Refer to Starter Motor Replacement (LP1, LY7) or Starter Motor Replacement (LS2) .
  5. Lower the vehicle.
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  7. Perform the CKP System Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn 
About FixVault