FixVault
Home › Cadillac › 2007 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1810 (Lighting System) › Repair Instructions › Stop Lamp Switch Replacement (With Adjustable Pedals) › Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stoplamp Switch
    GM1892146Courtesy of GENERAL MOTORS CORP.
  1. Install the stoplamp switch (1) to the power vacuum brake booster pushrod.
  2. Install the power vacuum brake booster pushrod with the stoplamp switch to the brake pedal pin.
    3. Fig 2: Brake Booster Pushrod Retainer
    GM1892145Courtesy of GENERAL MOTORS CORP.
  3. Install the power vacuum brake booster pushrod retainer (1).
  4. Rotate the pushrod retainer 360 degrees to verify the retainer is fully engaged in the groove on the brake pedal pin.
    5. Fig 3: Brake Booster Pushrod Retainer Bolt
    GM1892143Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  5. Install the power vacuum brake booster pushrod retainer bolt (1) and tighten to 10 N.m (89 lb in).
  6. Connect the stoplamp switch electrical connector.
  7. Install the driver knee bolster. Refer to Knee Bolster Replacement (Except Cadillac) , Knee Bolster Replacement (Cadillac) .
About FixVault