FixVault
Home › Cadillac › 2007 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 680 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Front End Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 1 .
  2. Disconnect the electrical connector.
    Fig 1: Disconnecting Front End Sensor Connectors - Zone 1
    GM859932Courtesy of GENERAL MOTORS CORP.
  3. Remove the connector position assurance (CPA) from the connector.
  4. Remove the sensor bolt.
  5. Remove the sensor (2) from the vehicle.
About FixVault