FixVault
Home › Cadillac › 2007 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 682 (Battery, Charging System And Starting System - Introduction) › Repair Instructions › Starter Shield Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2006 GMC Sierra, 2006 GMC Cab & Chassis Sierra, 2006 Chevrolet Silverado, and 2006 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with a 8.1L engine, install the starter heat shield.
    Fig 1: View of Starter Heat Shield, Bolts, & Nuts
    GM747162Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the starter heat shield bolts, and nut.

    Tighten: 

    • Tighten the bolts to 3 N.m (35 lb in).
    • Tighten the nut to 5 N.m (44 lb in).

  3. If equipped with a 4.8L, 5.3L, or 6.0L engine, install the starter heat shield.
    Fig 2: View Of Starter & Heat Shield
    GM663472Courtesy of GENERAL MOTORS CORP.
  4. Install the starter motor. Refer to Starter Motor Replacement (4.3L Engine)  or Starter Motor Replacement (4.8L, 5.3L, and 6.0L Engines)  or Starter Motor Replacement (8.1L Engine)  or Starter Motor Replacement (6.6L (LLY) Engine) .
About FixVault