FixVault
Home › Cadillac › 2007 › Escalade EXT › Repair and Diagnosis › Steering › Steering Linkage › Repair Instructions › Tie Rod Replacement - Inner › Installation Procedure

Installation Procedure

IMPORTANT: Perform the following procedure before installing the new tie rod ends:
  1. Remove all traces of the oil, grease, or other contaminants.
  2. Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the inner tie rod.
    4. Fig 1: View Of Inner Tie Rod End & J 34028
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the inner tie rod to the relay rod.

    Tighten:  Using the J 34028  (2) tighten the tie rod to 100 N. See Special Tools .m (74 lb ft).

  5. Install the outer tie rod end. Refer to Tie Rod Replacement - Outer .
  6. Install the engine protection shield, if equipped. Refer to Engine Shield Replacement .
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
About FixVault