Removal Procedure

WARNING: This page is about a different car, the 2007 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Remove the shock module from the vehicle. Refer to Shock Module Replacement .

Fig 1: View Of Spring Compressor
Courtesy of GENERAL MOTORS CORP.
Install the shock module into the spring compressor.
Mark the upper control arm assembly and insulator for proper installation.

Fig 2: View Of Compressor Forcing Screw & Coil Spring
Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The spring is compressed when the shock absorber moves freely.
Turn the spring compressor forcing screw (1) until the coil spring (2) is compressed.
Remove the magnaride sensor nut.

Fig 3: View Of Shock Absorber Upper Retaining Nut
Courtesy of GENERAL MOTORS CORP.
Remove the shock absorber upper retaining nut.
Remove the shock absorber from the shock module.
Loosen the compressor forcing screw until the upper mounting plate and coil spring may be removed.
Remove the upper control arm bracket assembly, insulator and coil spring from the spring compressor.