FixVault
Home › Cadillac › 2007 › XLR Base › Repair and Diagnosis › External Pages › Different car › Section 11 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Front End Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: Refer to SIR Caution .
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. Fig 1: Locating Front End Sensors
    GM1267620Courtesy of GENERAL MOTORS CORP.
  2. Remove the connector position assurance (CPA) (1, 6) from the wiring harness connector to the inflatable restraint front end sensor (3, 4).
  3. Disconnect the wiring harness connector (2, 5) from the front end sensor (3, 4).
    4. IMPORTANT: The front end sensor mounting fastener (8, 9) has left handed threads.
  4. Loosen the front end sensor mounting fastener (8, 9), which is located in the upper tie bar.
  5. Remove the front end sensor (3, 4) from the upper tie bar.
About FixVault