Scan Tool Output Controls

Scan Tool Output Control	Additional Menu Selections	Description
Column Calibration	Calibrate	The DPM can be commanded by using the scan tool to calibrate the tilt/telescope steering wheel. This must be done every time the DPM or the tilt/telescope actuators are replaced.
Column Lock Relay	On/Off	The BCM can be commanded by using the scan tool to energize the column lock enable circuit.
Default Position	Recall/Cancel	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the default position.
Memory 1 Exit Position	Recall/Cancel	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 1 exit position in the DPM memory.
Memory 1 Position	Recall/Cancel	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 1 position in the DPM memory.
Memory 2 Exit Position	Recall/Cancel	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 2 exit position in the DPM memory.
Memory 2 Position	Recall/Cancel	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel to the number 2 position in the DPM memory.
SCLCM Setup	-	The SCLCM can be commanded by the scan tool to be programmed to the installed vehicle. The module will then only work on the vehicle that it was programmed. This procedure is only necessary when installing a new module.
Telescope Motor	Forward/Rearward	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel forward or rearward.
Tilt Motor	Up/Down	The DPM can be commanded by using the scan tool to command the tilt/telescope steering wheel up or down.