FixVault
Home › Cadillac › 2008 › DTS 4.6 9 › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Rack & Pinion Boot Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Rack & Pinion Boot with J 22610
    GM297371Courtesy of GENERAL MOTORS CORP.
  1. Install the rack and pinion boot (3) to the steering gear.
  2. Install a new rack and pinion boot clamp.
  3. Using J 22610  crimp the rack and pinion boot clamp. See Special Tools .
    4. Fig 2: View Of Pinion Boot & Tie Rod End Clamp
    GM297362Courtesy of GENERAL MOTORS CORP.
  4. Install the tie rod end clamp (2) to the rack and pinion boot (1).
    5. Fig 3: Identifying Inner Tie Rod Assembly Jam Nut
    GM297360Courtesy of GENERAL MOTORS CORP.
  5. Install the hex jam nut (2) to the inner tie rod assembly.
  6. Install the outer tie rod. Refer to Rack and Pinion Outer Tie Rod End Replacement .
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Lower the vehicle.
  9. Adjust the toe alignment. Refer to Front Toe Adjustment .
About FixVault