Circuit/System Verification
- Ignition ON, observe the scan tool Sensor Voltage Feed Output parameter. The reading should be between 8.0-9.0 volts.
- Perform the LED Test, using the scan tool. Observe the operation of the three LEDs. All three LEDs should illuminate.
- If the system does not perform as specified, refer to Rear Parking Assist Malfunction in Circuit/System Testing .
- Observe scan tool Park Assist System Status parameter, while commanding the rear parking assist disable switch ON and OFF. The scan tool parameter should change between Enable and Disable.
- If the system does not perform as specified, refer to Rear Parking Assist Disable Switch Malfunction in Circuit/System Testing .