FixVault
Home › Cadillac › 2008 › Escalade EXT › Repair and Diagnosis › Accessories & Equipment › Collision/Avoidance › Object Detection System › Diagnostic Information and Procedures › Information Center Telltale Malfunction › Component Testing

Component Testing

  1. Ignition OFF, disconnect the harness connector at the RPA display.
  2. Connect a 10A fused jumper wire between the 12V supply circuit terminal 1 and B+.
  3. Connect a 10A fused jumper wire between the control circuit terminals listed below and ground.
    • Left amber LED control circuit terminal 2
    • Center amber LED control circuit terminal 3
    • Red LED control circuit terminal 4
  4. Verify that the appropriate LED illuminates.
    • If the component does not perform as specified, replace the RPA display.
About FixVault