FixVault
Home › Cadillac › 2008 › Escalade EXT › Repair and Diagnosis › Steering › Steering Linkage › Repair Instructions › Steering Linkage Inner Tie Rod Replacement › Installation Procedure

Installation Procedure

  1. Remove all traces of oil, grease, or other contaminants.
  2. Clean the threads of the steering linkage inner tie rod with denatured alcohol or the equivalent and allow to dry.
  3. Apply red LOCTITE™ threadlocker, GM P/N 12345493 (Canadian P/N 10953488) to the threads of the steering linkage inner tie rod.
    4. Fig 1: View Of Inner Tie Rod End & J 34028
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the steering linkage inner tie rod (1) to the relay rod using wrench J 34028  (2). See Special Tools .

    Tighten:  Tighten the steering linkage inner tie rod to 100 N.m (74 lb ft).

  5. Install the steering linkage outer tie rod. Refer to Steering Linkage Outer Tie Rod Replacement .
  6. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
  7. Adjust the front toe. Refer to Front Toe Adjustment .
About FixVault