FixVault
Home › Cadillac › 2008 › Escalade EXT › Repair and Diagnosis › Steering › Steering Linkage › Repair Instructions › Steering Linkage Shock Absorber Replacement › Installation Procedure

Installation Procedure

    Fig 1: Identifying Steering Linkage Shock Absorber Bolt & Nut
    GM1862841Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Use new steering linkage shock absorber nuts.
  1. Install the steering linkage shock absorber (2) to the vehicle.
  2. Install the steering linkage shock absorber (4) and nuts (1, 3).
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the steering linkage shock absorber nuts (1, 3).

    Tighten:  Tighten the nuts to 40 N.m (30 lb ft).

  4. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
About FixVault