FixVault
Home › Cadillac › 2008 › STS V › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 4.4L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake › Installation Procedure

Installation Procedure

    Fig 1: Locating Camshaft Sensor
    GM1247907Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the camshaft position sensor O-ring for wear or damage. If a problem is found, replace the O-ring.
  1. Lubricate the camshaft position sensor O-ring with engine oil.
    2. NOTE: Refer to Fastener Notice .
  2. Install the right bank intake camshaft position sensor (2) and retaining bolt.

    Tighten:  Tighten the camshaft position sensor retaining bolt to 10 N.m (89 lb in).

  3. Connect the camshaft position sensor electrical connector.
  4. Operate the engine and inspect the camshaft position sensor for engine oil leaks.
  5. Install the engine sight shield. Refer to Intake Manifold Sight Shield Replacement .
About FixVault