FixVault
Home › Cadillac › 2008 › STS V › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 4.4L - Introduction › Repair Instructions › Intake Air Duct Seal Replacement › Installation Procedure

Installation Procedure

    Fig 1: Rear Section Of Supercharger Inlet Duct
    GM1652890Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the supercharger inlet duct seal and clamp to the throttle body.

    Tighten the supercharger inlet duct seal screw clamp.

    Tighten:  Tighten the supercharger inlet duct seal screw clamp to 2.5N.m (20 lb in).

  2. Install the rear section of the supercharger inlet duct assembly. Refer to Supercharger Inlet Duct Assembly Replacement .
    3. Fig 2: Supercharger Inlet Duct Seals And Clamps
    GM1640656Courtesy of GENERAL MOTORS CORP.
  3. Install the supercharger inlet duct seals and clamps (2) to the front section of the supercharger inlet duct.
  4. Tighten the screw clamps on the supercharger inlet duct seals.

    Tighten:  Tighten the supercharger inlet duct seal screw clamps to 2.5N.m (20 lb in).

  5. Install the front section of the supercharger inlet duct. Refer to Supercharger Inlet Duct Assembly Replacement .
About FixVault