FixVault
Home › Cadillac › 2008 › XLR V › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 4.4L - Introduction › Repair Instructions › Air Cleaner Assembly Replacement › Installation Procedure

Installation Procedure

IMPORTANT: An improperly installed air cleaner or a distorted or missing intake air duct may cause a diagnostic trouble code (DTC) to set. Ensure that the air cleaner assembly and intake air duct is installed correctly and that there are no kinks or folds in the intake air duct. Debris in the air cleaner assembly or MAF sensor inlet screen, that may distort air flow can set a DTC.
    Fig 1: View Of Air Cleaner Assembly
    GM1685809Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner housing splash shields to the air cleaner assembly if previously removed.
  2. Install the air cleaner assembly to the vehicle.
    3. NOTE: Refer to Fastener Notice .
  3. Tighten the air cleaner outlet duct clamp at the supercharger inlet duct.

    Tighten:  Tighten the air cleaner clamp to 3 N.m (27 lb in).

  4. Install the MAF/IAT sensor if previously removed. Refer to Mass Airflow Sensor/Intake Air Temperature Sensor Replacement .
  5. Connect the MAF/IAT sensor electrical connector.
About FixVault