FixVault

Circuit/System Verification

NOTE: Perform this verification procedure only if the ignition has been OFF for eight hours or more.
  1. Verify that DTCs P0112, P0113, P0097, or P0098 are not set.
  2. Ignition ON, observe the scan tool IAT sensor, the IAT sensor 2, and the ECT sensor parameters. The readings should be within 15°C (27°F) of each other, and also the ambient temperature.
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.