FixVault
Home › Cadillac › 2009 › SRX 4.6 A, AWD › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Diagnostic Information and Procedures › DTC B1516 › Circuit/System Testing › Notes

Circuit/System Testing: Notes

  1. Ignition OFF, disconnect the harness connector at the battery current sensor.
  2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the low reference circuit terminal B and ground.
    • If greater than specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  3. Ignition ON, test for 4.8-5.2 volts between the 5-volt reference circuit terminal A and ground.
    • If less than the specified range, test the 5-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests, normal replace the BCM.
    • If greater than the specified range, test the 5-volt reference circuit for a short to voltage. If the circuit tests, normal replace the BCM.
  4. Ignition ON, test for 4.8-5.2 volts between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, replace the battery current sensor.
About FixVault