Removal Procedure
CAUTION:
Refer to Oxygen Sensor Caution
.
NOTE:
- Bank 1 on the LH2 engine in this vehicle is the right side of the engine while sitting in the driver seat.
- Sensor 2 is the second sensor down stream from the engine towards the rear of the vehicle.
- A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Disconnect the oxygen sensor electrical connector.
- Note the wire routing and attachment points for reassembly.
- Remove the oxygen sensor from the exhaust pipe.