Turn Signal/Multifunction Switch
WARNING: This page is about a different car, the 2008 Cadillac XLR. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector X1 at the turn signal / multifunction switch.
- Measure the resistance between the supply voltage circuit terminal 1 and the signal circuit terminal 5. Individually activate and hold each cruise control function switch and compare the resistance reading to the values for the On, Off, SET - and RES + switches.
- If any of the resistance measurements for the On, Off, SET - and RES + switches are not within the listed resistance values, replace the turn signal / multifunction switch.
| Function Switch | Minimum Resistance Value | Maximum Resistance Value |
|---|---|---|
| Off | O.L. | O.L. |
| On | 8.1k Ohms | 8.4k Ohms |
| - SET | 1.2k Ohms | 1.4k Ohms |
| + RES | 2.8k Ohms | 3.0k Ohms |