FixVault
Home › Cadillac › 2010 › CTS V, Standard › Repair and Diagnosis › Brakes › Antilock Brake System With Traction Control System & Stability Control System › Repair Instructions › Brake Pressure Modulator Valve Bracket Replacement › Removal Procedure

Removal Procedure

    Fig 1: Locating Vehicle Front Frame Brake Clips
    GM2090847Courtesy of GENERAL MOTORS CORP.
  1. Place the ignition switch in the OFF position.
  2. Remove the front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  3. Release the brake clips from the vehicle front frame (1).
    4. Fig 2: Identifying Right Side Engine Compartment Side Rail Brake Pipe Clips
    GM2090851Courtesy of GENERAL MOTORS CORP.
  4. Release the brake pipe clips (1) from the right side engine compartment side rail.
    5. Fig 3: Identifying BPMV Assembly Bracket Bolt
    GM2090856Courtesy of GENERAL MOTORS CORP.
  5. Remove the brake pressure modulator valve (BPMV) assembly bracket bolt (1).
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Remove the front air deflector. Refer to Front Air Deflector Replacement .
  8. Remove the right front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement .
  9. Remove the washer solvent container fasteners and position the washer solvent container aside. Refer to Windshield Washer Solvent Container Replacement (With CE4) or Windshield Washer Solvent Container Replacement (Without CE4) .
    10. Fig 4: Identifying BPMV Bracket Nuts
    GM2090860Courtesy of GENERAL MOTORS CORP.
  10. Remove the BPMV bracket nuts (1).
  11. Carefully lift the BPMV assembly from the bracket studs.
    12. Fig 5: Identifying BPMV & Bracket Assembly
    GM2090863Courtesy of GENERAL MOTORS CORP.
  12. Carefully lift the BPMV and bracket assembly (1) from the studs on the vehicle frame to access the BPMV bolt.

    Support the BPMV with heavy mechanics wire or equivalent.

    13. Fig 6: Identifying BPMV Bolt
    GM2090865Courtesy of GENERAL MOTORS CORP.
  13. Remove the BPMV bolt (1).
    14. Fig 7: Removing/Installing BPMV
    GM2090873Courtesy of GENERAL MOTORS CORP.
  14. Remove the BPMV bracket from the BPMV (1).
  15. Inspect the BPMV bracket insulator for damage and replace, if necessary.
About FixVault