FixVault
Home › Cadillac › 2010 › STS 3.6 V, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 3.6L - Repair Instructions › Repair Instructions › Primary Fuel Level Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: Refer to Gasoline/Gasoline Vapors Warning .
  1. Remove the primary fuel tank module. Refer to Primary Fuel Tank Module Replacement .
    2. Fig 1: Fuel Level Sensor Electrical Connector Locking Tab
    GM2030024Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not pull on the connector wires.
  2. Press in the locking tab (1) and disconnect the fuel level sensor electrical connector.
    3. Fig 2: Fuel Level Sensor Electrical Connector
    GM2029120Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel level sensor electrical connector (1).
    4. Fig 3: Fuel Level Sensor Locking Tab
    GM2029133Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not touch the resistor circuit board.
  4. Disengage the locking tab (1) on the fuel level sensor by pushing inward.
    5. Fig 4: Fuel Level Sensor & Stationary Lock
    GM2029159Courtesy of GENERAL MOTORS CORP.
  5. Slide the fuel level sensor (1) upward to the stationary lock (2).
    6. Fig 5: Fuel Level Sensor
    GM2029178Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel level sensor (1).
About FixVault