FixVault
Home › Cadillac › 2011 › CTS V, 4D Sedan, Automatic › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Controls And Fuel - 6.2L - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: Camshaft Position Sensor Assembly, Jumper Harness & Front Cover
    GM1484001Courtesy of GENERAL MOTORS CORP.
  1. Reconnect the camshaft sensor (5) and the jumper harness (4).
  2. Install the O-ring (6) on the camshaft sensor assembly (4 and 5).
  3. Reconnect the camshaft position sensor assembly (4, 5 and 6) and the engine harness connector (3).
    4. NOTE: Before installing the camshaft sensor assembly, apply a small amount of clean motor oil to the O-ring (6).
  4. Install the camshaft position sensor assembly (4, 5 and 6) in the front cover (7).
    5. CAUTION: Refer to FASTENER CAUTION .
  5. Install the camshaft position sensor mounting bolts and tighten to 25 N.m (18 lb ft).
  6. Install the generator assembly. Refer to Generator Bracket Replacement (LSA) .
About FixVault