FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › Body & Frame › Door Locks › Power Door Lock System And Release Systems › Diagnostic Information and Procedures › Power Liftgate Malfunction › Component Testing

Component Testing

Liftgate Object Sensor

  1. Ignition OFF, disconnect the harness connector at the right liftgate tape switch.
  2. Test for 10k ohms between the signal terminal A and the low reference terminal B.
    • If not within the specified range, replace the right liftgate tape switch.
  3. Disconnect the harness connector at the left liftgate tape switch.
  4. Test for 10k ohms between the signal terminal A and the low reference terminal B.
    • If resistance is not within the specified range, replace the left liftgate tape switch.

Liftgate Handle Switch

  1. Ignition OFF, disconnect the harness connector at the liftgate handle switch.
  2. Test for infinite resistance between the signal terminal A and the low reference terminal B with the switch in the open position.
    • If not the specified value, replace the liftgate handle switch.
  3. Test for less than 2 ohms between the signal terminal A and the low reference terminal B with the switch in the closed position.
    • If greater than the specified range, replace the liftgate handle switch.

Liftgate Close Switch

  1. Ignition OFF, disconnect the harness connector at the liftgate close switch.
  2. Test for infinite resistance between the signal terminal D and the low reference terminal A with the switch in the open position.
    • If not the specified value, replace the liftgate close switch.
  3. Test for less than 2 ohms between the signal terminal D and the low reference terminal A with the switch in the closed position.
    • If greater than the specified range, replace the liftgate close switch.

Liftgate Latch Assembly

  1. Install a 20A fused jumper wire between the control terminal 1 and 12 volts. Momentarily install a jumper wire between the control terminal 3 and ground. The liftgate latch assembly should perform the CINCH or RELEASE function.
    • If the function does not perform as specified, replace the liftgate latch assembly.
  2. Reverse the jumper wires, the liftgate latch assembly should perform the RELEASE or CINCH function.
    • If the function does not perform as specified, replace the liftgate latch assembly.

Interior Liftgate Control Switch

  1. Ignition OFF, disconnect the harness connector at the interior liftgate control switch.
  2. Test for infinite resistance between the signal terminal D and the ground terminal C with the liftgate open switch in the inactive position.
    • If not the specified value, replace the interior liftgate control switch.
  3. Test for infinite resistance between the signal terminal A and the ground terminal C with the liftgate disable switch in the inactive position.
    • If not the specified value, replace the interior liftgate control switch.
  4. Test for less than 3 ohms between the signal terminal D and the ground terminal C with the liftgate open switch in the active position.
    • If greater than the specified range, replace the interior liftgate control switch.
  5. Test for less than 3 ohms between the signal terminal A and the ground terminal C with the switch in the disable position.
    • If greater than the specified range, replace the interior liftgate control switch.
About FixVault