FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1210 (Hybrid Engine Electrical System) › Repair Instructions › Battery Current Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Negative Battery Cable Clip & Current Sensor
    GM1968028Courtesy of GENERAL MOTORS CORP.
  1. Remove the negative battery cable. Refer to Battery Negative Cable Replacement .
  2. Mark the location of the negative battery cable clip (1) and remove the clip from the cable.
  3. Mark the location of the battery current sensor (2) on the battery cable with tape for reference during installation.
  4. Remove the tape securing the battery current sensor to the negative battery cable.
  5. Squeeze the negative battery cable branches together.
    6. IMPORTANT: Note the orientation of the battery current sensor prior to removal.
  6. Slide the battery current sensor (2) off of the negative battery cable.
About FixVault