FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1210 (Hybrid Engine Electrical System) › Repair Instructions › Battery Negative Cable Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable Assembly
    GM1968354Courtesy of GENERAL MOTORS CORP.
  1. Install the negative battery cable assembly (1) to the vehicle and route the cable under the positive battery cable.
    2. Fig 2: View Of Negative Battery Cable Lead, Ground Lead & Bolt
    GM1968351Courtesy of GENERAL MOTORS CORP.
  2. Raise and suitably support the vehicle.
  3. Position the negative battery cable lead (3) behind the engine wiring harness ground lead (2).
  4. Place the engine wiring harness ground lead (2) and the negative battery cable lead (3) to the frame.
  5. Insert the anti-rotation tab on the engine harness ground lead into the hole in the frame.
    6. NOTE: Refer to Fastener Notice .
  6. Install the engine wiring harness ground lead bolt (1) to the frame.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  7. Lower the vehicle.
    8. Fig 3: View Of Negative Battery Cable, Ground Terminal Bolt & Ground
    GM1968348Courtesy of GENERAL MOTORS CORP.
  8. Position the engine wiring harness ground lead (2) behind the negative battery cable lead (3).
  9. Place the negative battery cable lead (3) and the engine wiring harness ground lead (2) against the engine block boss.
  10. Install the negative battery cable ground terminal bolt (1) to the engine block boss.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

    11. Fig 4: View Of Negative Battery Cable Clip
    GM1968346Courtesy of GENERAL MOTORS CORP.
  11. Install the negative battery cable clip (1) to the auxiliary BEC.
    12. Fig 5: Locating Battery Current Sensor & Engine Wiring Harness Electrical Connectors
    GM1968344Courtesy of GENERAL MOTORS CORP.
  12. Connect the engine wiring harness electrical connector (1) to the battery current sensor (2).
  13. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
About FixVault