FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1301 (Battery, Charging System And Starting System) › Repair Instructions › Battery Current Sensor Replacement (4.3L) › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Negative Battery Cable Clips & Battery Current Sensor
    GM1877144Courtesy of GENERAL MOTORS CORP.
  1. Remove the negative battery cable. Refer to Battery Negative Cable Replacement (With LU3) , Battery Negative Cable Replacement (With V8 Engine)  or Battery Negative Cable Replacement (With LMM) .
  2. Mark the location of the battery current sensor on the battery cable with tape for reference during installation.
  3. Remove the tape securing the battery current sensor to the negative battery cable.
  4. Mark the location of the negative battery cable clips (1) and remove the clips from the cable.
  5. Squeeze the negative battery cable branches together.
    6. IMPORTANT: Note the orientation of the battery current sensor prior to removal.
  6. Slide the battery current sensor (2) off of the negative battery cable.
About FixVault