FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1544 (Supplemental Inflatable Restraint System) › Diagnostic Information and Procedures › DTC B0074 › Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT:
    • The passenger presence sensor is not serviced separately. The PPS replacement with the passenger presence sensor must be serviced as a complete unit.
    • When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:
    • Passenger presence sensor
    • PPS module
    • Passenger presence sensor wiring harness connector
    • PPS module wiring harness connector
  1. Ignition OFF, disconnect the harness connector at the passenger presence module and inspect the component and harness sides for damage or corrosion.
    • If damage or corrosion is found, repair or replace as necessary.
  2. Ignition ON, test for 4.5-5.5 volts between the voltage reference circuit terminal 1 and ground.
    • If less that the specified range, test the voltage reference circuit for open/high resistance or a short to ground. If the circuit tests normal, replace the PPS module.
    • If greater that the specified range, test the voltage reference circuit for a short to voltage. If the circuit tests normal, replace the PPS module.
    3. IMPORTANT: The AIR BAG BATT Fuse that supplies B+ voltage must be removed to ensure the PPS module is inactive. An active PPS module may cause inaccurate resistance readings.
  3. Ignition OFF, remove the AIR BAG BATT Fuse. Test for less than 2.0 ohms between low reference terminal 4 and ground.
    • If greater than the specified range, test the low reference circuit for open/high resistance. If the circuit tests normal, replace the PPS module.
  4. Ignition OFF, disconnect the harness connector at the PPS module.
  5. Test for infinite resistance between the signal circuit terminal 6 and ground.
    • If less than the specified value, test the signal circuit for a short to ground.
  6. Ignition ON, test for less than 1 volt between the signal circuit terminal 2 and ground.
    • If greater than the specified range, test the signal circuit for a short to voltage.
  7. If all circuits test normal, replace the PPS module which includes the pressure sensor.
About FixVault