FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1558 (Fixed And MOVEABLE Windows System) › Repair Instructions › Rear Window Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If a window is cracked but still intact, crisscross the window with masking tape in order to reduce the risk of damage or personal injury.
    NOTE: Before cutting out a window, apply a double layer of masking tape around the perimeter of the painted surfaces and interior trim.
  1. Remove the window lower garnish molding. Refer to Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/A48) or Rear Window Lower Garnish Molding Replacement (Ext Cab/Crew Cab w/o A48) or Rear Window Lower Garnish Molding Replacement (Regular Cab) .
  2. Remove both rear seat headrests (extended cab). Refer to Head Restraint Replacement .
  3. Remove the rear sea (extended cab) only. Refer to Rear Seat Replacement (Crew Cab with A68) or Rear Seat Replacement (Extended Cab with AM7) or Rear Seat Replacement (Extended Cab with A68) .
  4. Remove the rear sliding window regulator motor bolt, if equipped. Refer to Rear Sliding Window Regulator Replacement .
    5. WARNING: If broken glass falls into the defroster outlets, it can be blown into the passenger compartment and cause personal injury.
  5. Cover to protect the following parts from broken glass:
    1. Upper dash pad
    2. Defroster outlets and A/C outlets
    3. Seats and carpeting
    6. Fig 1: Separating Urethane Adhesive From Window
    GM71179Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Glass and Sheet Metal Handling Warning .
    NOTE: Keep the cutting edge of the tool against the window.
  6. This will allow the urethane adhesive to be separated from the window.
    • Leave a base of urethane on the pinchweld flange.
    • The only suitable lubrication is clear water.
    • Use J 24402-A  , J 39040  or equivalent in order to remove the window. See Special Tools .
  7. Open the window, if equipped.
    8. Fig 2: Removing/Installing Rear Window
    GM379906Courtesy of GENERAL MOTORS CORP.
  8. With the aid of an assistant, remove the window from the opening.
About FixVault