FixVault
Home › Cadillac › 2011 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1558 (Fixed And MOVEABLE Windows System) › Repair Instructions › Rear Window Weatherstrip Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Closeup View Of Weatherstrip
    GM1852968Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install the bottom corners of the weatherstrip first to get the best seal for water intrusion, then the top corners and sides.
    IMPORTANT: Do Not remove the tape backing in this step.
  1. Install the bottom and top of the weatherstrip (1). Perform the following:
    1. Installing the weatherstrip (1), ensure that the single edge of the strip is located on the top and bottom.
    2. Install both bottom corners and top corners must be fitted tightly into the frame before pressing in place.
    2. Fig 2: View Of Rear Sliding Window Weatherstrip & Frame
    GM1852973Courtesy of GENERAL MOTORS CORP.
  2. Install the weatherstrip (1) to the frame. Perform the following:
    1. Installing the weatherstrip (1), ensure that the double edge of the weatherstrip is located on each side.
    2. Do one side at a time, remove the tape backing from the weatherstrip.
    3. Start in the center of the window frame, work the weatherstrip up and down the sides pressing in place.
  3. Install the rear sliding center window. Refer to Rear Sliding Window Replacement .
  4. Inspect the rear sliding window for proper operation.
  5. Water test to ensure no leaks.
About FixVault