FixVault
Home › Cadillac › 2011 › STS AWD › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Steering Linkage Outer Tie Rod Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Outer Tie Rod & Inner Tie Rod
    GM794580Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Install the same number of complete turns the rack and pinion outer tie rod end needed to remove as noted above.

  1. Install the rack and pinion outer tie rod end to the steering linkage inner tie rod. Do not tighten the steering linkage inner tie rod nut at this time.
  2. Connect the rack and pinion outer tie rod end to the steering knuckle.
    3. Fig 2: View Of Outer Tie Rod & Steering Knuckle
    GM794578Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  3. Install the rack and pinion outer tie rod end nut and tighten to 70 N.m (52 lb ft).
    4. Fig 3: View Of Outer Tie Rod Jam Nut
    GM794577Courtesy of GENERAL MOTORS COMPANY
  4. Tighten the steering linkage inner tie rod nut (1) and tighten to 65 N.m (48 lb ft).
  5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
About FixVault