FixVault
Home › Cadillac › 2012 › Escalade EXT › Repair and Diagnosis › External Pages › Different car › Section 1109 (Battery, Charging System And Starting System) › Repair Instructions › Generator Replacement (LY7) › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the generator to the engine.
  2. Install the generator upper bolt.
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    4. Fig 1: View Of Generator
    GM887706Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Install the generator lower bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    5. Fig 2: View Of Battery Positive Lead & Generator BAT Terminal Nut
    GM887703Courtesy of GENERAL MOTORS CORP.
  5. Install the battery positive lead (2) and the generator BAT terminal nut (3) to the generator.

    Tighten:  Tighten the nut to 13 N.m (115 lb in).

  6. Install the BAT terminal boot.
  7. Connect the electrical connector (1) to the generator.
  8. Lower the vehicle.
  9. Install the drive belt to the generator. Refer to Water Pump and Generator Belt Replacement .
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (Side Post) .
About FixVault