Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Yukon and 2008 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Brake Fluid Irritant Caution .

NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .

NOTE: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Place the ignition switch in the OFF position.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

Fig 1: View Of ABS Module Splash Shield Retainers

GM1965624

Courtesy of GENERAL MOTORS CORP.

Remove the antilock brake system (ABS) module splash shield retainers (1).

Fig 2: View Of ABS Module Splash Shield Bolts

GM1965625

Courtesy of GENERAL MOTORS CORP.

Remove the ABS module splash shield bolts (1).

Fig 3: View Of ABS Module Splash Shield

GM1965627

Courtesy of GENERAL MOTORS CORP.

Remove the ABS module splash shield (1).

Fig 4: View Of EBCM Bolts

GM2077044

Courtesy of GENERAL MOTORS CORP.

Remove all dirt and debris from the electronic brake control module (EBCM) and the brake pressure modulator valve (BPMV).
Disconnect the EBCM electrical connector.
Loosen, but do not remove, the EBCM bolts (1).

Fig 5: View Of EBCM

GM2077045

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not pry the EBCM from the BPMV. The EBCM must be pulled away from the BPMV evenly.

Using the loosened EBCM bolts as a guide, carefully pull the EBCM (1) evenly away from the BPMV to release the electrical connectors.

Fig 6: View Of EBCM Bolts

GM2077046

Courtesy of GENERAL MOTORS CORP.

Remove the EBCM bolts (1).

Fig 7: View Of EBCM

GM2077049

Courtesy of GENERAL MOTORS CORP.

Remove the EBCM (1).